Donut Card - Kit instructions ( Celebrate card)

Kit contents -

Card stock - Mint Macaron 8 1/2 x 5 1/2 folded in half,  Crushed Curry 6 inch by 2 1/2 inch,  small rectangle of Gumball Green card stock , small rectangle with sentiment (colors are listed based on the photo.  Kit colors may differ)   CELEBRATE Card also contains a punched balloon of Crushed Curry

DSP (Designer Series Paper - two-sided print) - 2 inch x 6 inch piece.  2 1/4 x 6 inch piece

White envelope

Adhere sentiment to the small rectangle.  

Adhere 2 x 6 inch piece of DSP to the 2 1/4 x 6 inch piece of card stock.  The card stock should create a thin border on the long sides - but not on the short sides. Adhere strip to the card front  - line up one end and the strip will extend about 1/2 inch.

From the back side, trim the DSP/card stock strip to match the card front.

 Peel the paper backing off the foam adhesives of the sentiment strip and then place where you want the sentiment.

If making the Celebrate card, Adhere balloon using the foam dimensional attached to the back.  You may want just a drop  of glue on the lower portion of the balloon so it adheres to the sentiment piece.  

The 2 1/4 x 6 inch piece of DSP is to decorate the envelope flap.

 Add glue to the outside of the flap.

 Place the piece of DSP onto the flap, lining it up to the fold. . 

From the back of the flap, trim the strip.

 Finished donut card and envelope. 

Finished Celebrate card.