Start with a square of card stock. Here are some measurements I used that work well. You have to score it into 3 rows of 3 squares so it works well if you use measurements that are easily divided by 3. Score each side of the square and you will wind up with the 9 squares.
3 inch square, score at 1 inch, handle 4 inches
3 3/4 inch square, score at 1 1/4 inch, handle 5 inches
4 1/2 inch square, score at 1 1/2 inch, handle 6 inches
5 1/4 inch square, score at 1 3/4 inch, handle 7 inches
6 inch square, score at 2 inch, handle 8 inches
Emboss the square if desired. Here I used the Elegant Lines embossing folder. It is easier to score the lines
Fold all the score lines in the same direction.
Fold all the score lines in the same direction.
Cut the score lines to the intersecting line on two opposite sides.
Round the four corners using the corner punch.
Round the four corners using the corner punch.
Fold up the corners on the sides that were cut until they overlap. Secure with a little Tombow glue.
Using the 1/16 inch punch, make a hole on either side to attach the handle.
Using the 1/16 inch punch, make a hole on either side to attach the handle.
Punch a hole at the ends of the handle at about 1/4 inch from the edge. I also embossed the handle. It was too long to get embossed the whole length so after I ran it through the first time, I turned it 180 degrees and embossed the other end, just pushing it through enough to meet what was already embossed.
Great tutorial... I like the lattice one, too.
ReplyDeleteThis is great. Must share!
ReplyDeleteThanks Cameo- let me know if you make any :-)
ReplyDelete