One Sheet Wonder #1

 This is a one sheet wonder for a 6 x 6 inch square of Designer Series Paper. 

This is template #1.  I made these 3 cards using this template. 

Basically cut the paper into 3x3 inch squares.  One of the squares you cut diagonally but not from corner to corner.  That is for Card C.  The other three squares you cut in half to make rectangles 3 x 11/2 inches. If the paper has an up and down pattern be sure to cut them all accordingly.  

Here are the three cards I made. They are clean and simple cut you can dress them up using mats, ribbons, embellishments, fussy cuts, embossing folders, etc. 

Card A - arrange three of the rectangles randomly on the card front. Add a sentiment and embellishments. 

Card B -  arrange three of the rectangles on the card front in a straight line.  I usually try to pull out three pieces that were side by side to make a continuous design but with the polka dots that doesn’t really matter. 

Card C - place one of the remaining pieces in the center top of the card front. Place the second piece below it lining up the sides and leaving a gap for a stamped sentiment.

Here is a set where I used mats and buttons.  Instead of cutting the one piece in the diagonal, I left it whole.