DSP strip card

A basic layout for DSP on a card.  So many beautiful DSP designs and colors, sometimes you just don't need much else. 

Strip of DSP at least 5 1/2 inches long and 2 inches wide (width can vary).  I like cutting the DSP in 2 inch strips and then cutting them in half so you wind up with 12 strips that are 2 x 6 inches. 

Coordinating card stock that is 2 1/4 inch wide and over 5 1/2 inches long. 

Scraps of the card stock and a neutral (white or ivory) for the greeting.

Layer the sentiment oval on the scalloped oval and add embellishments as desired.

Center the DSP strip over the card stock.  

Adhere the DSP strip to the card front.  

Place the sentiment on the card front without adhesive to figure out where you want to place it.

Once you decide, adhere with dimensionals. 

Trim off the excess from the DSP strip. An easy way is to turn the card front over and cut along the edge of the cardstock. 

With all the beautiful DSP that Stampin Up offers, you can make a wide variety of these cards.