Three Panel DSP

 Three Panel DSP

Supplies

Card base cut 8 1/2 x 11 or 4 1/4 x 11 fold in half

DSP  3 1/2 x 1 7/8 (2),  3 7/8 x 1 1/2

Coordinating card stock 5 1/4 x 4

Ribbon

Scraps to coordinate 

Lay out the DSP on the card stock to be sure you know which piece goes where and decide which on arrangement.  Glue one of the 2 pieces that are 3 1/2 inches long in a corner as shown.  Use the corners to place evenly along both sides.  

Add the other 3 1/2 piece again matching up the corner  

Add the third piece using the corners to position. 

Decide where you want to place the ribbon.  

Wrap piece of ribbon around where desired and secure it using tape. 

Check placement on front. Adjust if necessary. 

Take a second piece of ribbon and place behind the attached ribbon and  tie loosely.  Adjust position to your liking then pull securely. 

Trim bow ends. 

Adhere to card front. 

Add sentiment using dimensionals.